I. Reuse in Metallurgical Field
slag conditioner
After crushing and screening magnesia-carbon bricks, the granular materials can be used as converter slag-forming agents to replace light-burned dolomite and reduce the consumption of quicklime.
European steel mills mix dolomite-based waste refractory materials with refining slag to serve as slag-forming agents for electric arc furnaces, cutting lime consumption.
Regeneration of Ladle Refractories
Regenerated materials from waste magnesia-carbon bricks can be used to produce ladle fillers or recycled magnesia-carbon bricks, whose properties outperform virgin materials.
Recycled materials of alumina-magnesia-carbon bricks can be used to manufacture ladle lining materials. Even with a recycled material addition ratio up to 90%, excellent performance can still be maintained.
II. Development of Recycled Products
Regeneration of Refractory Products
The waste materials are processed into granules or fine powder through crushing, magnetic separation, screening and other processes, then mixed with raw materials to produce recycled refractory bricks, castables and other products. For example, recycled ASC bricks exhibit better performance than conventional ASC bricks.
Alumina-carbon waste can replace high-alumina bauxite to prepare iron trough ramming mixes and significantly improve service performance.
Composite Particle Processing
Waste refractory materials are subjected to physical and chemical treatments such as grinding and loss on ignition to produce composite particles, improving the quality of recycled raw materials.
III. Application in Environmental Building Materials and Auxiliary Materials
building materials
Siliceous waste can be used to produce lightweight thermal insulation boards and fire retardant coatings. Ground high-alumina waste powder can replace sand and aggregate to manufacture high-temperature resistant concrete.
Metallurgical Auxiliary Materials
Granules of waste refractory materials can be used as deoxidizers, slag formers in steelmaking or substitutes for foundry sand.
IV. Technological Innovation and Treatment Processes
Pretreatment Process
Impurity Removal and Purification: Manual sorting and water washing are adopted to remove soil impurities; mechanical cutting or knocking is used to separate slag layers and penetration layers.
Crushing and Grinding Processing: After coarse crushing by jaw crusher, the material is finely ground in a ball mill, combined with magnetic separation or acid leaching to remove metallic iron.
Graded Utilization Mode
Primary Utilization: After simple sorting, the materials are blended into low value-added products such as metallurgical auxiliary materials.
Advanced Utilization: The materials are separated and purified into chemical reagents or nano-powders for high value-added applications.
V. Typical Cases and Economic Benefits
Practice of Baosteel
Recycled magnesia-carbon bricks outperform virgin bricks, and the filler for electric furnace tapping holes has equivalent performance to forsterite.
The service life of ASC products recycled from iron trough waste is greatly improved.
European Experience
Italian steel mills use waste refractories as slag formers for electric arc furnaces, with an annual consumption of thousands of tons to achieve material balance.
VI. Environmental Protection and Policy Promotion
The utilization rate of waste refractory materials in China is less than 20%. However, with technological upgrades such as processing by grinding mills and policy guidance, the recycling utilization rate is gradually increasing.
Some enterprises have established closed-loop recycling systems and optimized treatment processes in compliance with environmental supervision requirements.
Development Trend: In the future, it is necessary to further develop fine sorting technologies, increase the added value of recycled materials, and improve industrial recycling standards and industrial chain collaboration.

